1969 FIAT SPIDER – SCCA G PRODUCTION RACE CAR $10,000.
NAARC CHAMPION, MANY REGIONAL AND NATIONAL WINS
HAS BEEN IN STORAGE SINCE 1997, ENGINE NOT ASSEMBLED, TRANS IS FRESH, NEEDS COMPLETE GOING OVER BEFORE RACING
Includes SCCA Log Books
Body – Fiberglass rear quarter panels, front fenders, hood, and spoiler.
Front brake cooling ducts. Jaz seat. . Halon fire system.
Autometer gauges. Unibody
reinforced with angle iron and welded to roll cage
Front Suspension – Suspension points relocated. Control arm bushings
replaced with spherical bearings. Tie rods and drag link replaced
with aluminum adjusting sleeves and rod ends. Zero bump steer.
Penske coil over shocks. Spare control arms and spindles
Rear Suspension – Three link suspension. Chrome-moly control arms
and panhard bar with rod ends. Fully adjustable. Penske coil over
Brake System – Four wheel disc brakes. Stock Fiat calipers and rotors.
Porterfield Racing pads. Tilton pedal assembly and master
Differential – Welded Fiat carrier with 3.90, 4.10, and 4.30 ratios.
Transmission – Saenz 5 speed gearbox with extra gear sets. McLeod
clutch on lightened Fiat flywheel. McLeod hydraulic throw out bearing.
Engine – 1438 cc. Two ported heads and intake manifolds with Serra
valves and springs. Four sets of cams (Reed, Lunati, Crower, PBS)
Two sets of Crower rods. Aries pistons. Two DMSA carburetors, bored with shaft less throttle plates. Spare blocks and cranks.
Accusump. Electronic ignition.
Trailer – 1990 Haulmark 22 ft. Torsion ride axles, ramp door, side door and awning. 1 ½ hp compressor. 3500 watt Coleman generator.
Spare Parts - Too many to list
For more info email@example.com
Got something I-car related that you'd like to part with?
1 post • Page 1 of 1